hjow to set up canon pixma mx922 for usb to mac

Hjow To Set Up Canon Pixma Mx922 For Usb To How To Check The

An Unknown Access Point is Displayed Access points in use nearby may also be detected.

Network Connection Wireless Connection Preparation for Connection Printer Setup Setup Procedure Selection Push Button Method Standard setup Other setup (Advanced setup) Disable WPAWPA2 Wired Connection Preparation for Connection Cable Connection Printer Setup.

If the power is on, a button on the Operation Panel (A) is lit.

The (blue) Wi-Fi lamp (C) lights up when wireless connection is enabled.

If the Push Button Method screen is displayed on the printer When you are unsure if your access point or router supports this technology, press the Stop button.

For details on pressing the WPS button, refer to the access point manual.

The (blue) Wi-Fi lamp on the printer flashes while searching for or connecting to the access point.

Select Standard setup.

Press the OK button.

Select your access point, then press the OK button.

One of the screens below will be displayed on the printer.

Select Other setup.

Select Advanced setup.

Select the security protocol used by the access point, then press the OK button.

Character entry is case-sensitive.

Press the left Function button (A).

Make sure that the passphrase is correct.

Press the left Function button.

When the left screen appears, press the OK button.

Notes on Wired Connection Make sure that the computer and router (A) are connected.

Hjow To Set Up Canon Pixma Mx922 For Usb To How To Check The

For details on how to check the settings, refer to the manual.

Follow the procedure below.

You can enter the characters when the keyboard is displayed on the printers LCD.

Password entry is case sensitive so press the center Function button (A) accordingly to switch between lower case, upper case and numeric characters.

Select the MAC address of the target access point on the displayed screen, then press the OK button.

For details on how to check the MAC address of the access point, refer to the manual supplied with the access point or contact its manufacturer.

Make sure that the WEP key entered for the access point is correct.

In addition, when using WEP key number 2, 3 or 4 of the access point, set to use WEP key number 1, or select a WEP key number by entering wireless connection settings of the printer directly.

Press the MENU button (A).

Use the buttons (B) to select WLAN setup, then press the OK button.

Make sure that the passphrase entered for the access point is correct.

See also the sections below: If the DHCP function of the access point is inactive, enable the DHCP function and configure wireless connection settings again.

The screen appears when connections are being attempted from multiple access points simultaneously.

Hjow To Set Up Canon Pixma Mx922 For Usb To Mac